Question 1

What is the difference between a standard tie rod and a water-stop tie rod?

Accepted Answer

A standard through-tie is withdrawn and reused after the concrete cures, leaving a hole through the wall that must be plugged. A water-stop tie rod keeps a middle section permanently embedded, fitted with a welded water-stop plate that breaks the capillary water path along the bar. It is required for basements, water tanks, tunnels, reservoirs and any water-retaining structure.

Question 2

What is a five-section water-stop tie rod?

Accepted Answer

It consists of two reusable outer threaded bars, two plastic cones and one embedded middle bar with a welded water-stop plate. After stripping, the two outer bars are unscrewed and reused on the next pour; only the middle section stays inside the wall. This keeps consumable cost low while producing a watertight wall penetration.

Question 3

What is the load difference between D15 and D20 tie rods?

Accepted Answer

D15 and D20 refer to the nominal bar diameter (about 15 mm and 20 mm). At the same steel grade, tensile capacity scales with cross-sectional area, so a D20 bar carries roughly 1.7 to 1.8 times the load of a D15. D15 is typical for residential slabs and light walls; D20 is used for thicker walls, higher pour rates and heavier hydrostatic loads. Final selection must always be checked against the formwork pressure calculation for the specific pour height and rate.

Question 4

Can you produce to our drawing or sample?

Accepted Answer

Yes. We manufacture to customer drawings or physical samples, including non-standard diameters, lengths, thread pitches and plate dimensions. Send the drawing with material grade, tolerance and surface treatment requirements.

Question 5

Which payment terms and Incoterms do you accept?

Accepted Answer

Payment: T/T, and L/C at sight for large orders. Trade terms: FOB Tianjin, CIF, CFR and EXW.

Thread	D15 / D20
Material	45# steel
Surface	Zinc plated / black

Grade	Catatan
Q235	Plain carbon steel. Economic option for light and medium formwork loads. Not heat treated.
45#	Medium carbon steel. The standard formwork tie rod grade in China; quenchable to class 8.8.
40Cr	Alloy steel. Higher hardenability and better fatigue performance than 45#; used where repeated reuse matters.
Class 10.9 bolt	Quenched and tempered alloy steel bolt used in the climbing cone set. Not electroplated without a documented baking cycle.
QT450-10	Ductile (nodular) iron with 450 MPa tensile and 10% elongation. Used for sleeves and embedded plates where toughness and castability matter.
HRB400	Hot-rolled ribbed bar (threaded steel) to Chinese standard. Used for embedded foot bolts; good bond with concrete.

Mur Penghubung

Spesifikasi

Spesifikasi Teknis

Proses Produksi

Jenis Bahan Dijelaskan

Aplikasi

Panduan Pembelian

Informasi Pembelian

Didukung oleh pabrik bersertifikat ISO

Mur Penghubung — Jawaban untuk Insinyur dan Pembeli

Mur Penghubung

Mur Penghubung

Spesifikasi

Spesifikasi Teknis

Proses Produksi

Jenis Bahan Dijelaskan

Aplikasi

Panduan Pembelian

Informasi Pembelian

Didukung oleh pabrik bersertifikat ISO

Produk Terkait

Papan Dasar Kotak

Cincin Plum

Kopling Bekisting

Mur Penghubung — Jawaban untuk Insinyur dan Pembeli